Sticker for mailbox front
Design: Puppy, dog, Welsh Corgi
NB: For technical reasons (photographic and computer), the actual appearance of the products may sometimes differ slightly from that of the photographs presented on the Site.
Installation Advice
-
For perfect adhesion, the surface must be dry and clean.
The surface temperature should be between 10°C and 30°C.
Wash and dry your surface before application. We advise you to clean the surface with rubbing alcohol (Do not use greasy solvents such as methylated spirits).
Remove the lock and the plastic plate (nameplate) then you can cut out these areas on the sticker with scissors or a cutter.
Peel the design from its backing.
Position the sticker; once the final location of your sticker is chosen, stick it down by smoothing out the air from the center outwards (use a soft cloth).
Tip: If small air bubbles appear anyway, carefully pierce them with a fine needle.Removal
The sticker has a permanent adhesive, however, if needed, it can be removed.
Method: Heat the surface with a hairdryer, this will soften the glue and the sticker will peel off easily. Then remove any residue with rubbing alcohol.
